Researchers in China have traced the mechanisms behind screen-printing-induced degradation in copper-plated silicon heterojunction (HJT) solar cells and proposed a comparatively simple screen-design change to limit it, according to a study published in Solar Energy.
Screen printing is a standard step in solar cell metallization, but the mechanical pressure and thermal treatment involved can damage the sensitive passivating contacts of HJT cells, raising recombination losses and lowering conversion efficiency. The problem is especially relevant for copper-plated HJT devices, which are seen as a route to cutting metallization costs and reducing reliance on silver.
Efficiency loss tracked across 15,000 cycles
Earlier investigations cited by the team showed conversion efficiency sliding from 26.2% to 25.7% over 15,000 consecutive printing cycles in commercial production. The loss came mainly from open-circuit voltage and fill factor, while short-circuit current density and electrical resistance stayed largely unchanged. Minority carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 printing cycles.
Using three-dimensional confocal microscopy, the scientists identified progressive wear of the screen mesh knuckles as the main cause. As the knuckles wear down, their contact area with the wafer grows, increasing mechanical stress on the passivation layers beneath. Scanning electron microscopy revealed no visible surface scratches, but photoluminescence measurements confirmed higher recombination losses, pointing to damage at the amorphous silicon/crystalline silicon interface.
Why photoresist printing differs from paste printing
Corresponding author Lang Zhou told pv magazine that photoresist printing for HJT cells differs fundamentally from conventional silver paste printing. In silver paste printing, the screen openings cover only 2–5% of the total area and an emulsion layer over the remainder keeps the mesh off the wafer. Full-area photoresist coating typically uses a screen without emulsion coverage so the resist spreads evenly across the whole wafer, which means the mesh touches the wafer directly and extensively on every printing cycle.
Emulsion buffer trades protection against uniformity
To break that direct contact, the researchers added an emulsion buffer layer and evaluated six patterns with emulsion coverage ratios ranging from 2.9% to 16.6%. The results showed a trade-off: higher emulsion coverage reduced mechanical damage but impaired photoresist distribution. A 4.7% coverage ratio gave the best balance, holding minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while maintaining relatively good coating uniformity.
The team attributed the improvement to the emulsion layer keeping the mesh from touching the wafer surface, which reduces cumulative mechanical damage to the sensitive passivation layers. Zhou said the findings demonstrate that a relatively simple modification to screen design can substantially mitigate printing-induced degradation and offer a practical approach to improving manufacturing reliability for copper-plated HJT cells.
Copper metallization gathers momentum
The work comes amid growing interest in copper as a substitute for silver in HJT contacts. In April 2026, researchers at China's Nankai University reported a silver-free HJT cell at 25.2% efficiency using plasma-induced interface engineering and copper electroplating, addressing adhesion, contact resistance and stability challenges at the ITO interface. Separately, scientists at Germany's Forschungszentrum Jülich reached 23.08% efficiency in a fully copper-metallized HJT cell, a relatively small penalty versus its silver-metallized counterpart, while cells combining silver-copper paste on the front with silver contacts on the rear reached 23.95%. Both results underline copper's potential to reduce silver consumption, although processing and electrical performance still require further improvement.
