Portal axles are prized by hardcore off-roaders because they raise a vehicle's drivetrain and improve clearance without relying only on suspension lift. The trade-off is cost: a typical set from suppliers such as 74Weld runs about $20,000. Zeph Gage's project takes a different route, installing a single portal axle at the rear of his Jeep XJ for roughly one-fifth of that price.
The build combines a Ford 9-inch axle housing, geared hubs from a Humvee and a set of Jesse Haines Fabrication HMMWV portal adapters. The key problem is direction. Two-gear portals like the Humvee units reverse the rotation of the input shaft. To make the Ford 9-inch work with them, Gage flipped the differential upside down so the driveline would spin the correct way. A Yukon Gear and Axle third member is then bolted to the differential, in effect turning low-pinion parts into a budget high-pinion arrangement.
Clearance gains and packaging choices
That arrangement is intended to add about six inches of clearance. It also retains full shock travel, a difficult goal with portal axles, and reduces stress on the differential itself. The result is expected to be effectively bulletproof, though that is an expectation built into the design rather than a demonstrated durability result.
Gage installed the portal only at the rear. The approach is common in remote-control rock crawlers: keeping the front solid axle avoids the packaging constraints that can arise when fitting portal axles to a vehicle that never had them from the factory. It also means the builder does not have to limit shock travel to make the parts fit, and the ride height does not rise to an extreme level.
This is not an off-the-shelf conversion. Gage carried out substantial custom fabrication, including homemade brackets and custom-tapped plates. The brake package uses a two-piece rotor paired with a Ford Fusion caliper. The Fusion hardware was chosen partly because it offers an integrated electric emergency-brake solenoid, as well as for clearance reasons.
A rear-end advantage
The finished Jeep XJ can drive over a five-gallon bucket while retaining several inches of spare clearance. That matters on obstacles where the rear end would otherwise hang up on features the front end can steer around. The rear-only layout gives Gage a targeted clearance gain without pushing the whole vehicle into a much taller, more heavily packaged build.
The project shows how fabrication and parts-bin engineering can approach a capability normally associated with expensive bolt-on systems, but it also illustrates the limits: the setup depends on custom brackets, modified brake hardware and careful matching of front and rear gearing. More detail on that gearing match is covered in an Outdoor Auto video.
