Japan's downstream aluminium imports fall 6.2% as Australia overtakes UAE as top supplier

Eight-month volumes slip to 1.36 million tonnes, with UAE shipments down 41.8 per cent and China up 54 per cent.

Japan imported 1.36 million tonnes of downstream aluminium products between January and August 2026, 6.2 per cent below the 1.45 million tonnes recorded in the same eight months of 2025, a reduction of about 90,000 tonnes. Inside that smaller total, the supplier ranking reshuffled: the UAE, the largest of the five leading suppliers a year earlier, slipped to second, and Australia moved into first place.

Annual totals have barely moved

The weaker eight-month figure sits alongside three years of near-flat annual volumes. Japan's downstream aluminium imports rose from 2.11 million tonnes in 2023 to 2.12 million tonnes in 2024, an increase of 0.3 per cent, and added 0.1 per cent in 2025 to remain at 2.12 million tonnes.

UAE: steepest volume drop, lower spending

UAE-origin shipments fell from 269,815 tonnes in January–August 2025 to 157,022 tonnes a year later, a 41.8 per cent decline and the largest among the five suppliers covered. Expenditure followed, from roughly USD 758 million to USD 517 million, down 31.8 per cent. Because spending fell less than volume, the implied average value per tonne of UAE material was higher in 2026 than a year earlier.

Australia leads on lower volumes

Australia's shipments eased 7.7 per cent, from 256,366 tonnes to 236,695 tonnes, but spending on them climbed 16.2 per cent, from about USD 710 million to USD 825 million. That divergence, less metal carried at more money, is the mirror image of the UAE pattern, where both volume and value contracted. Combined, Australia and the UAE supplied 393,716 tonnes in January–August 2026, against 526,182 tonnes a year earlier, a fall of 25.2 per cent.

China gains most, Brazil advances, Malaysia flat

China posted the strongest growth of the five suppliers: shipments rose from 89,735 tonnes to 138,214 tonnes, up 54 per cent, lifting it from fifth place to third. Brazil moved from 104,916 tonnes to 120,121 tonnes, a 14.5 per cent increase. Malaysia was effectively unchanged at 115,258 tonnes against 115,841 tonnes a year earlier, a dip of 0.5 per cent, and slipped a place in the ranking.

What the figures show and what they leave open

The comparison covers downstream aluminium products and the five leading suppliers only, so the movements describe a redistribution within a shrinking import book rather than the whole of Japan's aluminium trade. The data record volume and value shifts; they do not identify why individual suppliers gained or lost ground, and no explanation is attached to the UAE contraction, the Australian value increase or China's expansion. The practical signal for buyers and suppliers is narrower: the UAE's share of Japanese demand has fallen sharply, Australia now ranks first by volume, and Chinese material occupies a visibly larger place in the mix.

SV

Sienna Voss

Sienna Voss covers aluminum windows, laminated glazing, curtain walls, commercial doors, and facade attachment as parts of complete building-envelope assemblies. Her analysis uses ASTM E331 water-penetration testing for exterior windows and curtain walls, NFRC-rated fenestration U-factor and solar heat-gain coefficient where those ratings apply, and documented movement-joint and load measurements. She helps architects, facade engineers, and contractors decide which interface details need further testing, documentation, or supplier clarification before specification and installation.