Tremec's One-Off Manual C8 Corvette Shows the Cost of a Third Pedal

A Peitz-built track car demonstrates that a manual transaxle fits the C8 with limited hardware changes, though the $75,000 gearbox and remote shifter define the trade-offs.

A one-off Chevrolet Corvette C8 with a manual transmission exists, and it is not a static concept. Tremec’s running development car is a Peitz Performance C8 race car fitted with the supplier’s new manual transaxle, and Tremec allowed a journalist and several potential customers to drive it at a private track outside Howell, Michigan.

The car remains a track build rather than a production prototype. Its interior has little fit and finish, the shifter protrudes where the C8’s storage cubby and automatic selector normally sit, and the cabin is caged with a full harness. The seat also lacks meaningful adjustment, leaving the pedals a stretch for a 5-foot-7-inch driver.

Why the C8 launched without a manual

Chevrolet made the C8 the first mid-engine Corvette and offered it only with a dual-clutch automatic. Developing two new transaxles—one manual and one automatic—for a mid-engine car would have been costly, and the automatic-only route produced a highly capable Corvette without a third pedal. For enthusiasts, that left a gap.

Tremec’s answer is engineered around the C8’s existing mid-engine packaging. Peitz had to cut the tunnel to install clutch-pedal hardware, but the gearbox otherwise occupies the same space as the stock dual-clutch unit, with no elaborate mating hardware. The C8’s pedal box also has room for a clutch pedal, and the setup feels roomier than a previous-generation Camaro’s.

A different shift feel

The manual transaxle does not feel exactly like Tremec’s front-engine TR-6060 six-speed. Because the shifter is remotely mounted and linked by cables, it is slightly less precise and less “snick-snick” than the front-engine version, and it is less notchy. Some drivers may prefer the smoother edges; others may miss the more mechanical feel. Moving the engine forward or the shifter rearward would address the issue, but either solution would change the car’s layout.

The bigger obstacle is cost. The gearbox alone carries a price of about $75,000; Tremec says that figure will come down as volume increases. The total for building a manual C8 would rival a showroom-spec Z06. Tremec also says OEMs are interested—not necessarily or exclusively General Motors—and that other automakers want a high-torque manual transaxle. No customers were named.

The development car therefore proves that a manual C8 can work, but not that Chevrolet will offer one. For now, it remains a demonstration rather than a showroom option. The conversion shows the packaging is feasible and the driving experience is credible, but the business case still depends on volume, cost, and whether a small group of manual enthusiasts can justify a low-volume transaxle.

NV

Nerea Valdes

Nerea covers exterior protection and styling accessories, including vehicle covers, mud flaps, window deflectors, running boards, and fender flares, as an exterior fitment and weathering editor. Her assessments connect year-make-model and body configuration data with installation clearance, UV and moisture exposure, surface contact points, fastener corrosion, and documented load limits. She helps aftermarket category buyers, accessory distributors, fleet procurement teams, and installation shops verify fitment evidence, weathering test methods, packaging protection, and return-risk drivers before listing or specifying an exterior part.